Unfold The Lower Handle; Install The Upper Handle; Remove The Mulch Plug; Install The Grass Catcher - GreenWorks pro ULTRAPOWER 60X RANGE 60LM21P Manual Del Operador

7.2

UNFOLD THE LOWER HANDLE

13
1. Pull and turn the handle knobs (13) 90°.
2. Unfold the lower handle.
3. Line up the handle knobs in one of the three positions on
the brackets.
4. Turn the handle knobs 90° until they engage the holes in
the brackets.
Make sure that the two handle knobs are in the same
position.
WARNING
Do not damage or pinch the cables when you fold or unfold
the handle.
7.3

INSTALL THE UPPER HANDLE

15
14
4
1. Align the holes in the upper handle (3) and the lower
handle (4).
2. Put the bolts (14) through the holes.
3. Tighten the knobs (15) onto the bolts.
NOTE
3
English
4. Do the same operation on the other side.
7.4

REMOVE THE MULCH PLUG

5
11
The mower comes with the mulch plug installed properly.
To remove the mulch plug, please follow the instructions
below:
1. Open the rear discharge door (5).
2. Grasp the handle of the mulch plug (11), lift and pull it
out with some force, as it's installed at an angle.
3. The mulch plug must be re-installed back into the
discharge chamer when the grass catcher is removed.
7.5

INSTALL THE GRASS CATCHER

8
1. Remove the side discharge chute.
2. Open the rear discharge door (5).
3. Remove the mulch plug.
4. Hold the the grass catcher (8) by its handle and engage
the hooks (16) on the door rod (17).
5. Close the rear discharge door.
9
NOTICE
5
17
16
EN