Publicidad
Idiomas disponibles
Idiomas disponibles
6/17
4. Apply thinly grease to the han-
dlebar.
5. Apply grease to the end of the
throttle cables and cable pulley.
99000-25011:
6. Insert the Grip Heater (R) 5
into the handlebar. Then, install
the throttle cable No.1 first, then
No.2.
7. Set the stopper peg of the
switch box to the hole in the
handlebar and tighten screws.
NOTE: After tightening screws of
8. Reinstall the existing handlebar
balancer that was removed step
1.
Check for smooth opening
and closing operations of the
throttle. See if there is any
catch in the throttle operation.
9. Adjust the cable play:
1) Loosen the lock-nut.
2) Turn the adjuster so that the
3) Tighten the lock-nut.
4) Reinstall the boot.
GENUINE SUZUKI ACCESSORIES
SUZUKI SUPER GREASE
"A" or equivalent
the switch box, check to
make sure that the switch
box does not rattle.
WARNING
throttle grip has 2.0 – 4.0
mm (0.079 – 0.157 in) play.
FWD
Throttle cable No.1
Switch box
Hole
Hole
Grip Heater (R)
Stopper
peg
Throttle cable No.2
Lock-nut
Lock-nut
Boot
Boot
Adjuster
Adjuster
Publicidad
