Measurement Modes - Elcometer 456 Guia Del Usuario

9 CALIBRATION METHODS (continued)
CALIBRATION
METHOD
Auto
ISO
SSPC PA2
Swedish
Australian
10 MEASUREMENT MODES (MODEL T)

10.1 MEASUREMENT MODES

Three measurement modes are available: "Standard Mode", "Auto
Repeat Mode" and "Scan Mode".
To select the measurement mode, press Menu/Setup/Measurement Mode.
4
"Auto Repeat Mode" and "Scan Mode" are only available with an Elcometer 456
Ultra/Scan Probe. For further information contact Elcometer or visit
www.elcometer.com.
10.2 NAVSEA MODE
Displays the reading to the nearest 1mil (1µm) above 10mils (254µm)
and 0.1mil (0.1µm) below 10mils (254µm).
To select NAVSEA mode, press Menu/Setup/NAVSEA or Batch/New
Batch/NAVSEA.
en-7
R
MODEL
S, T
S, T
S, T
S, T
S, T
DESCRIPTION
Ideal for repetitive inspections. The user
stores known calibration foil thicknesses into
the gauge. When calibrating the user is
prompted to calibrate the gauge and the
gauge automatically adjusts the readings to
the stored foil thicknesses - simplifying and
considerably speeding up the calibration
process
Sets the calibration method to Zero Offset
and sets the Counted Average to 5 - in
accordance with ISO19840
Sets the calibration method to Rough/2
Point and sets the Counted Average to
3 - in accordance with SSPC PA2
Sets the calibration method to Rough/2
Point and sets the Counted Average to
5 - in accordance with SS standards
Sets the calibration method to Zero Offset,
and sets the Counted Average to 5 - in
accordance with AS standards
www.elcometer.com