Using The Side Protector Spacer; Recommendations; Maintenance - JANE iRACER Manual De Instrucciones

J. USING THE SIDE PROTECTOR
Your booster seat is fitted with a spacer which, in the event of
side impact, creates some distance between the backrest of the
seat and the collision zone.
This spacers should be placed on the side nearest the vehicle
door.
• To install it or remove it, press the button found on the top of
6
the spacer.
K. RECOMMENDATIONS
• Keep this instruction manual for future reference. Always keep
it in the compartment on the back of the seat (10).
• Make sure that inside the vehicle, all luggage and any other
object that could cause injury in the event of an accident is cor-
rectly secured or stored away.
• The i-RACER seat must be correctly fastened with the seat belt
and/or the ISOFIX system, even when it is not in use, as in the
event of an accident it could get flung about and cause injury to
the other occupants of the vehicle.
20
EN
L. MAINTENANCE
• Do not expose the upholstery to sunlight for prolonged peri-
ods, when the seat is not in use cover it up or store it in the boot
of the vehicle.
• Clean the plastic parts with soap and warm water, drying all
the parts thoroughly afterwards.
• The upholstery can be taken off for washing. Follow the in-
structions below:
-Headrest: Take the cover off from the top part of the headrest.
The remove the cover from the lower flap of the headrest.
-Seat cover: Take the cover off from the edges of the seat.
• Wash at a maximum temperature of 30ºC.
• To fit the upholstery again, follow the same steps in reverse.