Cleaning And Maintenance; Information About The Guarantee - JANE nurse DRIVER 2 Instrucciones

GB
7 USING FOR GROUP 1 (9-18 KG)
The safety seat should be installed in the forward facing position. Recline the safety seat to the required
position.
Check the red mark on the base of the safety seat for reference.
Step 7.1. Place the safety seat firmly against the back of the forward facing vehicle seat, as shown in the
diagram.
Step 7.2. Pull the lap and diagonal section of the vehicle seat belt until fully extended, place the diagonal part
of the vehicle seat belt through the headrest guide while placing the lap belt through the groove marked red.
Place the 2 parts of the belt (diagonal and lap section) under the pad, passing them from one side to the other.
Step 7.3. Tighten the vehicle seat belt by pulling first the lap section of the belt and then the diagonal part in
the direction shown in the diagram. Check that the vehicle seat belt is not twisted.
Step 7.4. Place the child in the safety seat and make sure that the shoulder straps are at the right height.
Check that the safety seat is correctly installed every time you drive with the child in the car. Gently twist and
pull the restraint system from side to side to make sure that the vehicle seat belt has not come loose and that
the safety seat does not move about. To remove the safety seat follow the instructions above in reverse order.
8 USING FOR GROUP 2 AND 3 (15-36 KG)
IMPORTANT: Before installing the safety seat remove the shoulder straps, crotch strap and lap strap.
Step 8.1. Place the safety seat firmly against the back of the forward facing vehicle seat, as shown in the
diagram.
Step 8.2. Place the child in the safety seat. Make sure that the child's back is flat against the back of the safety
seat. Pull the 3-point seat belt of the vehicle and place the diagonal section through the headrest guide, and
the lap belt through the groove marked red. Make sure that both the diagonal section and the lap section go
through the groove marked red on the other side before fastening the vehicle belt.
Step 8.3. Tighten the vehicle seat belt by pulling first the lap section of the belt and then the diagonal part in
the direction shown in the diagram. Check that the vehicle seat belt is not twisted.
Check that the safety seat is correctly installed every time you drive with the child in the car. Gently twist and
pull the restraint system from side to side to make sure that the vehicle seat belt has not come loose and that
the safety seat does not move about.
To remove the safety seat follow the instructions above in reverse order.
Note: The fully upright reclining position is suitable only for group 2 and 3.

CLEANING AND MAINTENANCE

These instructions are important. Read them carefully and keep for future reference.
Remove the harness system.
Remove the seat cover.
To replace the cover, keep the product.
Important: The seat cover is a safety feature. Do not use the safety seat without its cover. Do not put the
child's safety at risk by using a different replacement cover that has not been approved, as this would reduce
the level of protection offered by the seat.
Care instructions:
The cover is removable and washable at 30ºC. Line dry only.
30ºC
Machine
Do not bleach
wash, cold
If in doubt, consult either the child restraint system manufacturer or the retailer.

INFORMATION ABOUT THE GUARANTEE

- This item is guaranteed against manufacturing defects as stipulated in the legal Directives and/or
regulations in force on guarantees for consumer goods applicable to the European Union and those of the
country in which it is marketed.
- It is essential to present the purchase invoice or receipt in order to process the guarantee through the seller
of the item or, failing that, through the manufacturer.
- The guarantee excludes anomalies or faults caused by misuse, non-compliance with the safety regulations
and instructions for use and maintenance provided, or due to wear and tear caused by normal use and
regular handling of the item.
- The label containing the serial number of your model must not be torn off under any circumstances as it
contains information relevant to the guarantee.
P
Dryclean, any
Do not iron
solvent except
Trichloroethylene
Do not
tumble
dry
15