Wile Cotton Instrucciones De Uso página 18

EN
When the moisture content result is
displayed, you can erase the adjustment.
To do that press and hold F- button for
about 6 seconds. When the result value
on the display changes, you know that the
adjustment has been erased.
Always make several measurements,
because the moisture content in the
full load can vary greatly.
6. Exceptional result
If the measurement result exceeds the
upper limit of the measurement range, you
will see HI on the display.
If the measurement result falls below the
lower limit of the measurement range, you
will see LO on the display. If you get HI or
LO as a measurement result check if the
correct scale is used and always make
control measurements.
7. Battery
The meter runs on 9V battery of the type
6F22 or a similar alkaline battery. The
battery is included in a new meter and is
ready for use.
The meter gives a warning about the low
battery voltage with LOBAT-text in the
upper left part of the display.
If the battery is almost empty, the display
will show some random marks and
LOBAT- text can fade.
The battery cover is situated on the
bottom of the meter. Open the cover by
pushing the locking lever over the battery
18