Installing The Video Recorder - Dometic REC400 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 70

Installing the video recorder

The following indicators and connections are found at the front of the video
recorder:
No. in
fig. 3,
Designation
page 4
1
Green LED
2
Yellow LED
3
Red LED
4
Infrared receiver for remote control
5
Slot for SD card
6
Installing the video recorder
A
CAUTION!
• Install the device so that it cannot become loose under any
circumstances (sudden braking, accidents) and cause injuries to the
occupants of the vehicle.
• Never install the video recorder in areas where your head could hit it,
or in the path of an airbag. This could cause injury if the airbag opens.
• Insulate all connections.
• Secure the cables against mechanical wear by using cable binders or
insulating tape, for example on existing cables.
The installation location should be level.
➤ Affix the video recorder to a suitable location in the vehicle (e.g. in the boot or
under the seat).
➤ Affix the video recorder using the four fastening holes.
12
Description
LED lights up: The video recorder is
switched on
LED does not light up: The video recorder is
switched off
LED lights up: GPS ready
LED does not light up: GPS not ready/
not connected
LED flashes: The video recorder is
recording
LED does not glow: The video recorder is
not recording
LED flashes quickly: The playback mode is
switched on
REC400
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido