TROUBLESHOOTING
DAB reception (ISX-803D only)
Problem
Cannot tune into any DAB stations.
The initial scan operations are not
successful and "Not found" appears on
the DAB information display.
The DAB station reception is weak.
There is noise interference (e.g. hiss,
crackle, or jitter).
The DAB station information does not
appear or is inaccurate.
FM radio reception
Problem
Too much noise.
Too much noise during stereo broadcast.
Even with an outdoor antenna, radio wave
reception is weak. (Sound is distorted.)
Remote control
Problem
The remote control does not work
properly.
24
En
Cause
The initial scan operations were not performed.
There is no DAB coverage in your area.
The DAB signals are too weak.
The DAB signals are too weak.
There is no DAB coverage in your area.
The DAB signals are too weak.
The antenna needs to be repositioned.
The DAB signals are too weak.
The DAB station may be temporarily out of
service, or the DAB station information is not
provided by the DAB broadcaster.
Cause
The antenna may be connected improperly.
The radio station you selected may be far from your
area, or the radio wave reception is weak in your
area.
Multipath reflection or other radio interferences
may have occurred.
Cause
The remote control may be operated outside its
operation range.
The remote control signal receiver on the unit
(☞ P. 3) may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the remote control
signal receiver on the unit and the remote control.
Solution
Perform the initial scan operations (☞ P. 13).
Check with your dealer or WorldDMB Online at
"http://www.worlddab.org" for a listing of the DAB
coverage in your area.
Change the height, direction, or placement of the
antenna.
Check with your dealer or WorldDMB Online at
"http://www.worlddab.org" for a listing of the DAB
coverage in your area.
Change the height, direction, or placement of the
antenna.
Contact the DAB broadcaster.
Solution
Make sure the antenna is connected properly
(☞ P. 3) or use a commercially available outdoor
antenna.
Try manual tuning to improve the signal quality
(☞ P. 15) or use a commercially available outdoor
antenna.
Change the height, direction, or placement of the
antenna.
Solution
For information on the remote control operation
range, refer to "How to use the remote control"
(☞ P. 1).
Change the lighting or orientation of the unit.
Replace the batteries with two new ones.
Remove the obstacles.