ELICA HILIGHT Montaje Y Modo De Empleo página 24

Operation
This product is designed to work with an Elica remote control,
either supplied with the product or purchased separately as an
optional.
To control the hood via remote control, the affiliation
procedure must be carried out.
CAUTION!
To begin, the hood must be disconnected and then
reconnected to the power supply and the affiliation procedure
must be carried out within the first minute of connection to the
power.
Read the instructions supplied with the remote control, which
provide detailed instructions on affiliation and correct use.
Note: the Speed 4 (and the Speed 5, where applicable) if
selected, will activate for a limited period of time after which
Speed 2 is automatically enabled.
Remote control connection (if applicable)
Once the remote control has been connected, this will be
displayed on the hood:
both LEDs flash.
Note: Using the remote control, delayed shut-down can be
programmed based on the aspiration speed (power) enabled
at that moment:
Speed 1 (low aspiration): 20 minutes
Speed 2 (medium aspiration): 15 minutes
Speed 3 (high aspiration): 10 minutes
Filter Saturation indicator lights
At regular intervals, the LEDs on the hood indicate the need to
carry out filter maintenance.
Note: The filter saturation signal is visible for a few seconds
when the hood is switched on; within this time, the
saturation indicator lights must be reset.
Flashing Green LED: carry out maintenance on the
grease filter.
Red flashing LED: carry out maintenance on the charcoal
filter (only for hoods operating in "Filtration Version").
Note: Run the "RESET FILTRES" command via the
remote control.
Activating/deactivating the filter saturation indicator
light
Note: Run the procedure with the hood switched off. The
charcoal filter saturation indicator light is usually
deactivated.
If no control is given within maximum 10 sec, the hood
automatically exits this function, at any time, and returns
to the previous state.
Press and hold the B+C keys (Simultaneously) to enter
the setup menu:
Briefly press button C to select the filter to be set up:
Grease filter:Green
Charcoal filter: Red
Briefly press button B to activate (the 2nd LED flashing)
or deactivate (2nd LED off).
Note: the LEDs light up for a limited number of seconds
after which they turn off to indicate that the indicator light
has been activated (or deactivated).
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will stop working each
time the window in the room, on which the KIT is applied, is
closed.
- The KIT must be electrically connected to the device
by qualified and specialised technical personnel.
- The KIT must be separately certified in accordance
with the safety standards relative to the component
and its use with the device. Installation must be
carried out in accordance with current regulations for
domestic systems.
CAUTION:
- the wiring of the KIT to be connected to the device
must be part of a certified safety extra low voltage
(SELV) circuit.
- the manufacturer of this device declines all liability
for any inconveniences, damage, fires caused by
defects and/or problems associated with malfunction
and/or incorrect installation of the KIT.
24