Before First Time Use - Angelcare AC300-A Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.2 SELECT THE CRIB LEG YOU WILL BE USING TO SECURE THE CORD COVERS
RECOMMENDED
6
5
4
3
2
Fig 1
OR
6
5
4
3
2
1
Fig 2
1.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
3
5
4
6
3
2
1
4
5
5
8
1) Use the crib leg by the wall closest to
the Nursery unit (fig 1). In cases where
the Nursery Unit is across the room, use
the leg closest to the Nursery Unit to
position the covered wire (fig 2). It is
always preferable that the covered cord
run along a wall.
1
1) Remove the mattress from the crib.
2) Place the Sensor Pad - printed side up
- on top of the hardboard at the center
of the crib.
3) Run the connection pin, warning label
and the first 5 cord covers down along
the backside's of the crib leg, between
the mattress support and the inside
edge of the crib.
4) Bring the first 4 cord covers down
the floor, and keep the 5
cord cover
fth
vertically, along the backside of the crib
leg, (between the mattress and the
inside edge of the crib).
5) Remove any cord slack to make sure
no parts of the cord are loose.
6
3"
6
7
CLIC!
4
3
2
1
8
9
4
3
2
1
10
WARNING
STRANGULATION HAZARD
• Remove all slack from Sensor Pad Cord.
• When lowering the mattress support
as your child grows, slide the vertical
Cord Cover (5) upward so it remains
approximately in the center between
the mattress support and the floor. Slide
the Sensor Pad Cord through the Floor
Cover to eliminate any additional slack.
• The Sensor Pad is not designed for use
with adults, children or infants older
than 24 months.
6) Place the 6
th
cord cover approximately
3 inches from the edge of the mattress
support.
7) Snap together the remaining cord
covers that will run along the floor.
8) Remove any cord slack to make sure
no parts of the cord are loose.
9) Peel off the double-sided tape on the
4
th
cord cover and place it securely
under the crib leg.
10) Install the Nursery Unit on a flat, stable
surface facing the crib at a distance
of at least 3 ft. (0.9 m) and plug the
Sensor Pad cord into the Nursery Unit.
11) Check to make sure the Sensor Pad has
not moved from position.
12) Place the mattress back inside the crib.
The Sensor Pad functions with any size
and type of mattress except memory-foam
mattresses and hollow frame mattresses.
The hardboard maintains a constant pressure
on the Sensor Pad, enabling it to detect the
baby's movements even when the baby is at
the edges of the crib.
• Discontinue used
of the Sensor Pad
when child is older than 24 months.
Remove Sensor Pad from crib and store
for future use.
• BEFORE FIRST TIME USE: To test
that the unit is ready for use, refer to
instruction manual on how to test that
the installation has been done
E
N
9

Publicidad

Tabla de contenido
loading

Tabla de contenido