Troubleshooting; Technical Specifications - Angelcare AC300-A Manual Del Usuario

TO ADJUST SENSOR PAD SENSITIVITY LEVEL:
Turn the Nursery Unit sensitivity dial from
less sensitive (0) to very sensitive (5).
For optimal results begin with the sensitivity
level dial on the 3 rd bar, adjusting the
sensitivity by half a bar increases or
decreases as required.
IMPORTANT
• The Sensor Pad is not designed for use with adults,
children or infants older than 24 months.
• Once you are finished using the Sensor Pad, please
remove it from the baby's crib and store it away.
3.3 - BATTERIES
The Angelcare ® Movement Monitor is battery operated.
• Batteries will last approximately 3 to 4 months.
YOU ARE NOW READY
TO USE YOUR MONITOR
3.4 - ACTIVATING THE TIC FUNCTION
1
2
12
NOTE:
If you are experiencing false
alarms, adjust the sensitivity level.
BATTERY ALARM
• When Nursery Unit produces a rapid
clicking sound, change batteries promptly.
1) Slide switch ON to activate the 'TIC'
function. A green light will flash as well
to indicate movement.
2) Slide switch OFF to remove 'TIC'
sound. The green light will continue to
flash to indicate movement function is
still working.
NOTE:
If the green light does not appear but a red
light is flashing; or if there are false alarms,
adjust the sensitivity level (Step 3).

TROUBLESHOOTING

FALSE ALARMS
• Turn OFF the Nursery Unit.
• Verify the connection between the Sensor Pad and the Nursery Unit.
Unplug and reconnect the cord.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the
Sensor Pad measuring at least 13" x 13" (33 x 33 cm) and 1/4 inch (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to Step 3.1.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is ON.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement
from outside the crib.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
• You may need to decrease the sensitivity, refer to Step 3.1.
ALARM INDICATOR LIGHT IS FLASHING RED
(MONITOR IS BARELY DETECTING MOVEMENT)
• Make sure there is no bedding between the mattress and the Sensor Pad.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring
or slat base, place a hard board between the crib base and the Sensor Pad measuring at
least 13" x 13" (33 x 33 cm) and 1/4 inch (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements.
Sensitivity may need to be adjusted, refer to Step 3.1.
NO POWER
• Check or replace batteries.
• Make sure Monitor is ON.
If you experience a problem that is not noted in this manual,
please do not return the product to the store. If you are not completely
satisfied or have any questions:
United States and Canada: please contact us at: angelcare@cdecinc.ca
Other countries: please contact your local distributor.
We may have a simple solution to your problem.

TECHNICAL SPECIFICATIONS

Power Supply:
2 AA alkaline batteries (not included)
Caution: To reduce the risk of electric shock, do not expose this
product to rain or moisture.
Batteries:
• DO NOT mix old and new batteries.
• DO NOT mix alkaline and standard (carbon-zinc) batteries.
E
N
13