Accessories And Consumables; Troubleshooting - GYS Cutter inverter 25K Manual Del Usuario

ACCESSORIES AND CONSUMABLES

Accessories
Consumables
Regularly check the wear condition of the protective tip, nozzle and electrode or in case of significant reduce of the
cutting speed.
It is advised to replace at the same time the nozzle and the electrode.
Tip
Nozzle
Diffuser
Electrode

TROUBLESHOOTING

Anomalies
The machine delivers no power.
The green working indicator is on.
The thermal protection indicator is
continuously on.
The machine delivers no power.
The green working indicator is on.
The thermal protection
blinks 2 times then
(35K/31FV).
The error indicator blinks quickly
(35KF)
The machine delivers no power.
The green working indicator is on.
The thermal protection
blinks quickly (35K/31FV).
The error indicator blinks quickly
(35KF).
By pressing the trigger, the air flows
but the pilot arc is not working.
The electrical arc switches off after
about 3 seconds.
If you feel tingling sensation, when
the unit is on and you put your hand
on the welding unit's body.
Plasma 31FV : After having switched
off the plasma (position « O »), the
ventilator and the compressed air
continues to run.
The unit does not supply power. The
three lights flash when switching on the
unit (35K)
Compass divider kit (ref.
040205)
For circular cutting up to
134 cm diameter.
Provided with
magnetic, with center pin,
with thread
Replace if cracked or damaged
Clean if the inside of the nozzle is blocked or
dirty.
Replace if the opening is deformed or if the
size of the orifice has half increased.
Replace if lateral orifices are bolcked.
To replace: if a significant cavity appears at
the electrode center.
Causes
The thermal protection of
the welding unit is on.
The input voltage is higher
ondicator
than 230V + 15% for plasma
lights off
25K and 35KF, 85-265V for
plasma 31FV
Torch defect.
indicator
Air supply too weak.
Consumables shabby.
Earth problem.
The welding
correctly connected to the
earth.
Torch Cooling phase.
The unit is switched on with
the trigger pressed
3 axes :
Plasma 25K
040182
040151
Wait until the end of the cooling phase.
Check your electrical network or your
electric generator then switch off and on
your machine.
Check your torch assembly.
Increase the air pressure, then switch off
and on your machine.
Check and change the consumables, then
switch off and on your machine.
Check the earth clamp is well connected to
a clean area (not painted and not fat) of
the part to cut.
unit is not
Check the plug and the earth of your
electrical network.
Normal behaviour of the machine, wait for
the end of the cooling phase (+/-15 sec).
Release the trigger. If the problem remains
send back the machine
Trolley (Ref. 040199)
For a comfortable use and be
at the advised height
For optimizing the cutting
performances and increasing
the nozzles life-time.
Plasma 35KF Plasma 31FV
040229
040212
040175
040168
Remedies
040236
040212
7