Clearing Jams; Anti-Dust Cap - Freeman PF20LM Manual Del Usuario

Clavadora para pisos para listones en l de calibre 20 clavadora para pisos par
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MODEL: PF20LM

CLEARING JAMS

Occasionally, fasteners may become jammed in
the firing mechanism of the tool, making the tool
inoperable. To remove a jammed fastener,
follow these steps below:
1.
Disconnect the tool from air source.
Empty the magazine. Make sure all
2.
fasteners are removed.
3.
Try to fire the tool into a piece of scrap wood
or flooring to make sure that it's incapable
of firing any fasteners.
Set the tool on its side to expose three
4.
Bolts(K).
5.
Remove three Bolts(K) and Nose Cover(L) to
expose the jammed fastener. (See figure
5&6)
6.
Remove jammed fastener, using pliers or a
screwdriver if required. (See figure 7)
7.
Return the Drive Blade back to its original
position. (See figure 8)
Replace the Nose Cover (L) and three
8.
Bolts(K). (See figure 9)
9.
Reconnect tool to the air source, then
reload the tool with fasteners.
10.
Press the tool against a piece of wood, and
test fire the fasteners several times to check
for proper operation. If the tool is properly
firing, you may continue using the tool. If the
tool fails to perform properly, immediately
discontinue use and have the tool repaired
by a qualified service technician.
Figure 5
Nose Cover(L)
Bolts(K)
10
HTTP://WWW.FREEMANTOOLS.COM
Figure 6
Bolts(K)
Nose Cover(L)
Figure 7
Jammed
Fastener
Figure 8
Drive Blade
1-888-669-5672
MODEL: PF20LM
Figure 9
Nose Cover(L)
Bolts(K)
Make sure there is no fastener in the
magazine before clearing a jam.
MAINTENANCE
Any time inspection, maintenance, and
cleaning are done:
◆Disconnect the tool from the air source.
◆Empty the magazine completely.

ANTI-DUST CAP

Each tool is packed with an anti-dust cap on the
air connector, check it after unpacking. Keep
the anti-dust cap to cover the air connector
when the tool is not in use to prevent debris
from entering the tool.
LUBRICATION
Frequent, but not excessive, lubrication is
required for best performance. Oil for the tool is
added through the air line connection and will
lubricate the internal parts.
1.
Disconnect the air supply from the tool to
add the lubricant.
HTTP://WWW.FREEMANTOOLS.COM
2.
Turn the tool so the air inlet is facing up.
Place 2-3 drops of pneumatic fastening tool
oil into air inlet. Do not use detergent oils, oil
additives, or air-tool oils as these lubricants
will cause accelerated wear to the seals and
bumpers in the tool, resulting in poor tool
performance and frequent tool maintenance.
After adding oil, run tool briefly. Wipe off any
3.
excess oil from the cap exhaust.
CAUTION:
Lubricate tool only with specified
lubricants.
CAUTION:
The work surface can become damaged
by excessive lubrication. Proper
lubrication is the owner s responsibility.
'
Failure to lubricate the tool properly will
dramatically shorten the life of the tool
and void your warranty.
11
1-888-669-5672

Publicidad

Tabla de contenido
loading

Tabla de contenido