DJI D-RTK Guia De Inicio Rapido página 8

Air System Installation and Connection
The following uses the Antenna Bracket III, DJI DATALINK PRO 900, DJI Matrice 600, D-RTK and DJI A3
Flight Control System to illustrate a typical installation and connection.
Installation
1. Mount the two GNSS Antennas to the Antenna Bracket III with four M3.0×6.5 screws.
2. Attach the D-RTK Processor (working as the Air System) and the DATALINK PRO Mobile Station to the
Upper Expansion Plate with double-sided tape.
• Use the Antenna Bracket II if using other types of aircraft and follow the requirements below:
a. Ensure that the two Antenna Brackets
and the distance between the two Antennas is greater than 25 cm (the farther apart, the better).
b. The two Antenna Brackets
c. The two Air System antennas should be kept at the same height.
Connection
1. Using the Antenna Cables, connect the Ground System's "ANT1" port to one Antenna as the Master
Antenna, and the "ANT2" port to the other Antenna as the Slave Antenna.
2. Attach the DATALINK PRO Mobile Station's Antennas and tidy them with clips.
3. Connect the Air System CAN/UART port to the DATALINK PRO Mobile Station CAN/UART port with an
8-pin Cable.
4. Connect the Air System "CAN1" port to any CAN1 port on the A3 flight controller with a 4-pin CAN Cable.
5. Connect the Air System "POWER" port to the power port on the aircraft with an Air System Power Cable
© 2017 DJI All Rights Reserved.
6
form a straight line through the aircraft's center of gravity,
II
should be equidistant from the aircraft's center of gravity.
II
.
I