Automatic Registration; Programming Mode; Activating Programming Mode - Disty distybox 300 Instrucciones De Operación

4. Connect the
distybox
5. Fit
distybox
The
station before it can be used. The registration process can
normally be carried out using the "Automatic registration"
EN
function.
"Programming mode" allows you to set various parameters
distybox
to modify the
base station. Additional parameters allow the distybox to be
set according to your personal preferences. Manual registra‑
tion can also be carried out in this mode.

Automatic registration

distybox
The
it has not been registered on any other base station yet.
To do this, the PIN on your base station must be set to "0000"
or "1111".
1. Connect the power supply unit (adapter) to your
distybox
300
2. Connect your telephone to the
handset on the hook.
3. Ensure that your base station enables an additional
cordless phone to be registered.
4. During the registration process, the
located close to your base station.
5. Start the registration procedure for the device on your
DECT / GAP base station as if you were registering an
additional cordless unit. Instructions on how to do this
will be given in the operating manual for your base station.
6. Plug the power supply unit into a power socket.
The registration process will be started automatically.
20
distybox
to the power supply.
300
300 in place.
300 must be registered on your DECT / GAP base
300 to suit the functionality of your
300 can be registered automatically, assuming
.
distybox
300 , leaving the
distybox
should be
300
Operating instructions
7. The registration process has been successful if the LED
flashes at intervals of approx. 10 seconds.
NOTE If the registration process has not been completed successfully
within approx. 3 minutes, register the device manually in

programming mode.

Programming mode
NOTE Programming mode on the
within the first 10 minutes after plugging in the power supply
unit. This prevents the parameters being changed accidentally
during operation.

Activating programming mode

distybox
To put the
300
as follows:
1. Connect your telephone to the
2. Connect the power supply unit to your
3. Plug the power supply unit into a power socket. Leave the
phone on the hook for at least 30 seconds.
4. Lift the handset on your telephone. Depending on whether
distybox
or not your
station, you will either hear a busy tone or a dialling tone.
5. On your telephone, enter:
6. You will hear a positive acknowledgement tone.
Optional step:
7. Enter the PIN for the
telephone.
NOTE The PIN only needs to be entered if a new PIN has been set up
beforehand in programming mode.
NOTE Access to programming mode can be protected using the PIN!
Operating instructions
distybox
300 can only be activated
into programming mode, proceed
distybox
.
300
distybox
300 .
is already registered on a base
300
* * 9
distybox
300 via your
21
EN