Setting Parameters In Programming Mode - Disty distybox 300 Instrucciones De Operación

8. You will hear the special dialling tone indicating that
programming mode is active.
You can now enter the parameter codes to change the
relevant features of your
EN
EXAMPLE Let's say, for example, you want to use your
a base station with an ISDN telephone connection. Activate
programming mode as described above in points 1 – 8 and
then proceed as follows:
1. Enter the programming code for "Connection to an ISDN /
analogue Line":
2. To activate the feature, enter:
3. You will hear a positive acknowledgement tone, followed
by the special dialling tone once more. The feature is now
active.

Setting parameters in programming mode

NOTE Not all the features offered by the
supported by every DECT/GAP base station. Refer to the
operating manual for your base station to clarify which
features you can use.
Programming mode needs to be activated before this pa‑
rameter can be set. The function‑programming process is
concluded by entering
acknowledgement tone. You will then hear the
special dialling tone once more, which means that you can
continue programming other functions. With the exception of
programming points 90, 91 and 99, the change is effective
without having to restart the
If an invalid value is entered during programming, a negative
acknowledgement tone is sounded, the procedure is cancelled
and you will hear the special dialling tone once more.
22
distybox
300 .
distybox
300 on
4 0
0 #
distybox
300 are
#
and confirmed by the positive
distybox
300 .
Operating instructions
If during programming no input is made for one minute, the
procedure is cancelled and you will hear the special dialling
tone again.
Programming mode can be exited at any time by replacing
distybox
the handset; the
mode.
Function
Manual registration
distybox
of the
300
The base station PIN needs to be entered to register the
distybox
300 . A PIN with 0 to 8 digits will be accepted by the
distybox
300 . After entering
acknowledge tone. Leave the handset off hook and wait
until you hear again the special dial tone, which means that
the registration is completed. If the registration process has
not been completed successfully within approx. 3 minutes,
crosscheck the settings of the base station and try again.
Access to programming mode can be protected using the
four‑digit PIN.
Connection to
an ISDN/analogue
line
This setting has to be used if your base station is connected
to an ISDN phone line. Send Keypad Information, while
connection Keypad information will be suppressed, so it is
possible to transmit DTMF signals.
Suppress Keypad Information: This setting has to be used if
your base station is connected to an analogue phone line.
Operating instructions
will then be returned to normal
300
Parameter Other input
code
1 Base PIN #
#
you will hear the positive
40 0 #
40 1 #
23
EN