Mounting Instruction - Arachnid BULLSHOOTER ILLUMINATOR 3.0 Instrucciones Y Reglas

Step 3
While the pins are inserted into correct position, use your thumb to push the hinge pin to snap
into the dartboard and lock in. Repeat on the bottom hinge. After you have one door fully locked
into place, repeat steps for the other door.
PLEASE NOTE THE DOORS ARE INTENDED TO BE INSTALLED ONE TIME ONLY. DO
NOT REMOVE THE DOORS AFTER THEY ARE INSTALLED.
Choose a location to hang the dartboard where there is about 10 feet of open space in front of
the board. The "toe-line" should be 7' 9 1/4" from the face of the dartboard.
Locate a wall stud and place a mark 75.75" from the floor. This mark is for the top screw hole.
For the bottom screws, you will measure 62.5 inches from the floor. Using a pencil, make a
reference mark very lightly on the wall (do not drill a hole in the "reference mark" that you have
made). You will then need to place a mark 6.31 inches to the left of that reference mark. That will
be the location for the left side bottom screw. You will then make another mark 6.31 inches to
the right of the original reference mark you made. That will be the location for the right side
bottom screw. Drill holes into the marks you made.
Mount the dartboard on the wall by lining up the holes on the back of the dartboard with the
screws. It may be necessary to adjust the screws until the board fits snugly against the wall.
Center of Bullseye should be 5' 8" from the floor when finshed.
All Rights Reserved
©2014 Escalade Sports

MOUNTING INSTRUCTION

6
ILM300
For Customer Service Call 1 -800- 526 - 0451