JUKI MO-6 14/LB-6 Serie Manual De Instrucciones página 60

2
2
2
6
3 4
3
4
switch 2 to call up "U1 2". The num-
10) Press
ber of stitches to be sewing from the point at which
the material sensor detects the material edge at
the end of sewing to the point from which the
thread tension is released. Press
switch 4 to change the setting. If you do
or
not need to change the setting, proceed to step
11).
switch 2 to call up "U1 3".
11) Press
The number of chain-off stitches can be set. Press
switch 3 or
ting. If you do not need to change the setting,
proceed to step 12).
switch 2 to call up the display "FUn_
12) Press
UT1_" again. Then, turn the power off. Now, the
LB function settings are confirmed.
Do not omit steps 9) to 12) even if you do
not need to change the settings of "U1 1"
to "U1 3". If you omit these steps, the LB
function settings are not confirmed.
switch 3
switch 4 to change the set-