Publicidad
Idiomas disponibles
Idiomas disponibles
Tail Pipe Tip Adjustment
•
The end of the exhaust tips should be recessed 25mm (1 inch) from the vertical projection of the rear fascia to avoid any incidental
contact with the hot exhaust tip in service.
•
Refer to the illustration below for proper tip alignment with the fascia. The offset can be measured using a plum bob or a vertical
straight edge that is perpendicular to the ground. Before fully tightening the clamps, ensure that the rubber hangers are located
properly on the exhaust hanger rods.
4. Check your exhaust system for proper clearance under the vehicle.
5. Once position has been determined to be correct, tighten all the clamps to 32-35 ft-lbs. Tighten the front flange to 18-22 ft-lbs.
6. Before starting your vehicle, make sure to check all wires, hoses, brake lines, body parts and tires for safe clearance from the exhaust
system.
7. Start the vehicle and check for any leaks. If any leaks are found, determine the cause (such as loose or incorrectly positioned clamp)
and repair as necessary.
8. Drive the vehicle to your dealer and have the calibration updated to the correct Stage Kit.
NOTE: Calibration Part Numbers listed below may get updated. Please call the TCSC help desk (Refer page -1) for the
latest calibration Part Numbers including those for MY 2018 and MY 2019 which are not listed here.
Sonic 1.4 L Turbo Stage Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Hatch Back (RS-model) - Exhaust with Dual Tips
25 mm (1")
Bottom View
Exhaust with single Tip
25 mm (1")
Bottom View
REV 24JA17
19MY16
01JL16
24JA17
25 mm (1")
Side Section View trough the Inboard Tip
25 mm (1")
Side Section View through Tip
23444740
PART NO.
DATE
Previous Revisions are Archived
Revision - Vinod Kaushal
Revision - Vinod Kaushal
Revision - Vinod Kaushal
5
SHEET
REVISION
21
OF
AUTH
JHFGT
JNNJW
JXZDR
Publicidad
