Acson international A5WMY10KR Manual De Operación página 13

01_EN_3P257186-2A.fm Page 12 Saturday, October 31, 2009 2:19 PM
Adjusting the Airflow Direction
■ To adjust the louvers (vertical
blades)
Hold the knob and move the louvers.
(You will find a knob on the left-side and the right-side
blades.)
• When the unit is installed in the corner of a room, the
direction of the louvers should be facing away from the
wall.
If they face the wall, the wall will block off the wind,
causing the cooling (or heating) efficiency to drop.
CAUTION
• Always use a remote controller to adjust the angles of the flap. If you attempt to move it
forcibly with hand when it is swinging, the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the air outlet, a fan is rotating at a high speed.
NOTE
■ Notes on the angles of the flap
• The flap swinging range depends on the
operation. (See the figure.)
• If the air conditioner is operated in HEAT or
DRY operation with the flap kept stopped in
the downward direction, the flap will
automatically start operating in approx. an
hour in order to prevent dew condensation.
12
In DRY operation or COOL operation
Stop operation
0˚
COMFORT AIRFLOW
5˚
Upper limit
45˚
Lower limit
In HEAT operation
Stop operation
0˚
15˚
Upper limit 50˚
45˚
Lower limit
COMFORT AIRFLOW
In FAN operation
Stop operation
0˚
5˚
Upper limit
45˚
Lower limit