Master Forge DGY784CP Manual Del Usuario página 12

OPERATION INSTRUCTIONS
Any fuel supply cylinder used must be constructed and marked in accordance with specifications
for propane cylinders of the U.S. Department of Transportation (DOT) CFR 49, or the Standard
for Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods, CAN/CSA B339.
The appliance is to be used only with the 20-pound, vertical standing vapor withdrawal type tank
and must include a collar to protect the cylinder valve.
(A) DO NOT store spare LP cylinders under or near the smoker.
(B) NEVER fill cylinder more than 80% full.
(C) Do not store cylinder indoors.
WARNING
If instructions (A), (B),(C) above are not followed exactly, a fire causing death or serious injury may occur.
This smoker is designed to operate on LP (Liquid Propane) gas only. The gas cylinder used must include
a collar to protect the cylinder valve. The cylinder supply system must be arranged for vapor withdrawal.
Do not allow dirt or foreign material to get into or onto tank connection when it is not attached to the fuel
supply system. Use the protective cap provided.
WARNING
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT
FIRE, DAMAGE AND/OR INJURY.
The cylinder outlet must have Type 1 gas connection termination in order to mate with gas hose
provided with smoker. The pressure regulator and hose assembly supplied by the manufacturer
with the appliance must be used. Replacement pressure regulators and hose assemblies must
be those specified by the appliance vendor.
This unit is not to be utilized with a non-self-contained LP-gas supply system.
Valve/pressure regulators are factory set to the correct operating pressures. No attempts should be
made to adjust these settings.
DISCONNECT THE LP TANK
Make sure that the knob on the LP tank is turned clockwise
Hold the regulator in one hand, turn the coupling to the valve outlet counterclockwise
and unthread the connection by hand only. Do not use tools.
Put the protective cap (if present) back onto the LP tank valve and coupling nut.
Always hang the regulator on the lifting handles (A) while not in use, disconnected from
the LP tank, and when the unit has cooled down.
STORE THE TANK IN A PROPER PLACE AS INDICATED IN THIS MANUAL.
to a full stop (CLOSED).
12