Assembly Or Installation Instructions - Master Forge DGY784CP Manual Del Usuario

ASSEMBLY INSTRUCTIONS
1. Attach the legs.
Align one leg (A) with mounting holes on the
bottom of the smoker body (I). Thread bolts
through holes from outside of unit. Nuts are
pre-welded to the cabinet. Repeat for other
3 legs (A). Tighten all bolts (AA) with a
Phillips screwdriver.
Hardware Used
AA
1/4-20 x 5/8 Bolt
2. Attach the burner and control unit.
Open the upper door of the smoker body (I)
Turn the burner and control unit (B) upside
down and place it on the bottom of the smoker
body (I), making sure the 4 mounting holes on
the burner and control unit (B) are aligned with
the holes on the smoker body (I).
Note: The control knob should be on the same
side as the door. Check that the burner is
properly installed on the orifice before attaching
the burner and control unit (B).
Thread bolts (AA) through holes from outside
of unit. Securely tighten the unit to the bottom
with a Phillips screwdriver.
Hardware Used
AA
1/4-20 x 5/8 Bolt
3. Attach the smoke stack.
CAUTION: This unit is HEAVY! Do not
attempt this step without assistance!
Close and lock the two doors. With the
assistance of a helper, stand the unit upright
on its legs on a firm and level surface. (Make sure
that the burner/control unit and legs are attached).
Open the upper door. Position the smoke stack
(H) with control arm to the left as shown. Using
the 3 bolts (AA) and nuts (BB), attach smoke
stack (H) to the top of smoker body (I).
Securely tighten with a Phillips screwdriver.
Hardware Used
AA
1/4-20 x 5/8 Bolt
1/4-20 Flanged
BB
Washer Nut
1
x12
2
x4
3
x3
x3
8
A
AA
I
UU
B AA
Control
arm
HH HH
I
AA
H
BB
I