Troy-Bilt FLEX 23AAAA8X711 Manual Del Operador página 16

To replace the upper and lower deck belts:
Three belt keepers must first be removed, followed by removal of
the upper, then lower belts. Follow these steps to service either
or both of the mowing deck belts:
1. Lower mowing deck to the lowest cutting position.
2. Remove the belt keeper shown in Figure 6-6 by removing
the four hex screws that secure it.
3. Remove the belt keeper secured to the vertical portion of
the mowing deck attachment by removing the hex screw
that secures it. See Figure 6-7.
16 S 6 — S
ection ervice
Figure 6-6
Figure 6-7
4. Remove the left belt keeper shown in Figure 6-8 by
removing the two hex screws that secure it.
Figure 6-8
5. Loosen, but do not remove, the idler pulley used on the top
deck belt.
6. Remove the cotter pin from the height adjustment link, and
slide the link off of the height adjustment pivot assembly.
See Figure 6-9.
Figure 6-9