Final Assembly - Heath Zenith 8416 Manual De Instrucciones

FINAL ASSEMBLY

1. Push the wires into the junction box.
2. Slide the fixture base onto the long fixture screws.
Tighten decorative nuts securely against fixture base.
3. Assemble the light cover onto the base by inserting
the tabs on the bottom of the cover into the slots
on the bottom of the base. Tilt the cover toward the
base and tighten the screw at the top of the cover.
4. Caulk around the fixture base with silicone weather
sealant. IMPORTANT: Do not caulk drainage hole.
Decorative Nut
Base
Cover Screw
Light Cover
206149-02
Long Fixture Screw
Junction Box
Base
1. Turn on the circuit breaker and light switch.
2. To test the light during daylight, cover the photocell
with black tape and ensure the light works properly.
3. Monitor light control to verify that the lights come on
at night and turn off during the day.
Power Requirements .... 120 VAC, 60 Hz
Wattage ........................ Max. 12 x 0.5 Watt LED
LUX control level ........... Approximately 20 lux
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
3
Photocell
TEST AND ADJUSTMENT
SPECIFICATIONS
Drainage
Hole