Final Assembly; Care And Cleaning - Heath Zenith 8813 Manual De Instrucciones

FINAL ASSEMBLY

1. Double check that all wiring connections are securely connected.
2. Align the mounting bolt on the back of the fixture with the
center hole in the mounting bracket. Note: The mounting bolt is
designed to stay in the light fixture.
3. Tighten the mounting bolt securely being careful not to overtighten
(see Figure 3).
4. Push the rubber plug firmly into the mounting bolt hole on the
light fixture (see Figure 3).
5. Caulk around mounting plate and mounting surface with silicone
weather sealant (see Figure 4).
6. Turn on the circuit breaker and light switch.
7. To test the light during daylight, cover the photocell with black
tape and ensure the light works properly.
8. Uncover the photocell and your unit will operate automatically
– on at dusk, off at dawn.
9. If needed, gently grasp the lamp heads and tilt them up or down
or side to side to adjust the light coverage area (see Figure 5).
CAUTION: Burn hazard. Allow the light fixture to cool
before touching.
Set the Adjustable Color Temperature dial to the desired light color
(see Figure 6).
• Turn the Adjustable Color Temperature dial toward the "Blue" color
to increase the color temperature toward daylight (5000K).
• Turn the Adjustable Color Temperature dial toward the "Orange"
color to decrease the color temperature toward warm (3000K).

CARE AND CLEANING

• To prolong the original appearance, clean the light fixture with
clear water and a soft, damp cloth only.
• Do not use paints, solvents, or other chemicals on this light fixture.
They could cause a premature deterioration of the finish. This is not
a defect in the finish and will not be covered by the warranty.
• Do not spray the light fixture with a hose or power washer.
209841-01
OPERATION
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 3
Figure 4
Figure 5
Color Temperature Dial
Figure 6
Photocell
3