Descargar Imprimir esta página

Safety Message To Maintenance Personnel - Federal Signal Corporation 191XL Instrucciones De Instalación Y Servicio

Publicidad

Idiomas disponibles

Idiomas disponibles

Listed below are some important safety instructions and precautions you should
follow:
Read and understand all instructions before operating this system.
Any maintenance to the light system must be done with power turned
off.
Any maintenance to the light system must be performed by a trained
electrician who is thoroughly familiar with all applicable national and
local codes in the country of use.
Never alter the unit in any manner. Safety of the unit may be affected if
additional openings or other alterations are made to the internal compo-
nents or housing.
The nameplate should NOT be obscured, as it contains cautionary and/or
other information of importance to maintenance personnel. Ensure the
nameplate remains readable if the housing's exterior is painted.
If the dome is damaged in any way, it MUST be replaced.
After performing any maintenance, test the light system to ensure that it
is operating properly.
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
To maintain the vapor-tight enclosure, do not damage the globe or threads
while disassembling or reassembling the unit. Lubricated threaded joints
exposed for long periods of time may attract small particles of dirt or other
foreign materials. Housing and cover joints should be reassembled immedi-
ately, with all the threads fully engaged.
A.
Cleaning Enclosure.
Maintenance procedures sometimes require fixtures to be hosed down for good
housekeeping. The circuit should be turned off prior to hosing down.
The fixture should be cleaned periodically to maintain maximum light output.
Only mild, non-abrasive cleaning agents should be used. The glass globe should be
regularly inspected for scratches and chips, and if damaged, MUST be replaced.
B.
Lubrication.
Threaded joint on cover should be kept well lubricated with a corrosion in-
hibiting grease such a petrolatum or soap-thickened mineral oil. If corrosive materials

SAFETY MESSAGE TO MAINTENANCE PERSONNEL

NOTE
-4-

Publicidad

loading