Installation Instructions - Koala Kare KB208 Instrucciones De Instalación Y Funcionamiento

INSTALLATION INSTRUCTIONS

Oval Baby Changing Station
Model Number KB208
Step 1.
Remove the station from the shipping container and check for any freight damage. Identify the best
location for installing the unit. Hold the unit in place and open the bed. Make sure you have taken the
operating clearance into consideration.
Step 2.
Determine the best method of mounting based
on the type of wall. You may have to purchase
toggles.
Step 3.
The oval unit has four mounting holes provided
in the back wall, positioned on a 16" (406 mm)
stud center. If possible, locate the wood or
metal studs for fastening the unit in the desired
location. If the walls do not have studs on 16"
center as outlined, make sure at least one side
of the unit is installed into the stud. Use toggles
for holes on the opposite side.
Step 4.
Find the stud where you will be attaching the left side of the unit to the wall. Measure up from the floor
42¼" (1,073 mm), at the center of the stud, and mark the wall. Mark remaining holes using a measuring
tape to make sure the holes are precisely positioned. Hold unit in place to verify. Use a 1/8" drill bit to
make pilot holes then use four ¼" x 3" panhead wood screws with washers (supplied) to secure the unit
to the studs.
If the wall surface is masonry or tile over studs, use a 7/32" masonry drill bit for the pilot hole until you
hit the stud. Change bit to 1/8" regular drill bit. Use four ¼" x 3" panhead wood screws with washers
(supplied).
If the wall has wood studs that are not on 16" (406 mm) centers, has metal studs or an underlying
surface of concrete block, drill with a ½" masonry bit. (You may have to purchase toggles before
installing.) You must allow a minimum of inside wall space for toggles to turn, depending on toggles
used. Insert and tighten toggles.
Step 5.
Once the unit has been secured to the wall, use the two screw hole plugs provided to cap the upper two
mounting hole recesses. Position the plug over the recess and push it into place using hand pressure.
Do not hammer the plug in as it will damage the plug. Once the plug is flush with the surface stop
pushing and install the second one.
Step 6.
Position Koala sign (supplied) on the outside of the restroom door. Replacement parts can be purchased
from your local distributor or by calling toll free 888.733.3456 or 303.539.8300.
2