Denon DHT-500SD Instrucciones De Operación página 20

ENGLISH
7 After the above settings are completed, press the
ENTER button.
• The "SYSTEM SETUP MENU"
reappears.
✽ To cancel the setting after adjusting
Display the channel level adjustment screen, then
use the , , and cursor buttons
to select "LEVEL CLEAR" and "YES". The level
settings for all the speakers are set to 0 dB.
NOTES:
• When you adjust the channel levels while in the
SYSTEM SETUP CHANNEL LEVEL mode, the
channel level adjustments made will affect ALL
surround modes. Consider this mode a Master
Channel Level adjustment mode.
• After you have completed the SYSTEM SETUP
CHANNEL LEVEL adjustments, you can then
activate the individual surround modes and
adjust channel levels that will be remembered for
each of those modes. Then, whenever you
activate a particular surround sound mode, your
preferred channel level adjustments for just that
mode will be recalled. Check the instructions for
adjusting channel levels within each surround
mode on page 23.
[4] After completing system setup
• Once the speaker settings, delay time setting and
channel level adjustments are made, there is no
need to reset them unless the AV components or
speakers are changed or the speakers are moved to
different positions.
1 At the SYSTEM SETUP MENU,
press the SETUP button.
• The changed settings are
entered and the on-screen
display turns off.
This button can be pressed at any time during
the system setup process to complete the
process.
NOTE:
• If the quick system settings are selected after
setting up the system using the system setting
change menu, the speaker and delay time
settings are changed to the values preset for the
quick system settings.
20
screen
SETUP
Remote
control unit
NOTES:
Channel level setting by Remote Control unit. (TEST TONE, CH SELECT button)
• This section describes channel level setting by Remote Control unit.
CH
-
0 +10
CALL /10
(1)-1,
TEST TONE INPUT MODE SURROUND FUNCTION
(1)-3
TUNER TV / VCR
A / V DVD AV AMP
+
DVD
-
STATUS
MUTING
SETUP TONE /DIMMER
(1)-2,
ENTER
(1)-2,
(2)-2
SURROUND
CH SELECT PARAMETER
(2)-1
- +
VCR CH
RETURN DISPLAY MENU TOP MENU
PBC
ANGLE AUDIO SUB TITLE
RC-973
(1) AUTO MODE
1 Press the TEST TONE button.
TEST TONE
Remote control unit
2 Test tones are output from the different
speakers. Use and buttons to adjust so
that the volume of the test tones is the same for
all the speakers.
• The channel to be adjusted can be changed
using the CH SELECT button and the (
and ) cursor buttons on the remote
control unit during the adjustments using the
test tones.
Remote control unit
3 After completing the adjustment, press the
TEST TONE button.
TEST TONE
Remote control unit
(2) MANUAL MODE
• Even after adjusting using the test tones (AUTO
MODE), the various channels can be adjusted
using the procedure described below to suit the
program source and your preferences.
1 Select the speaker whose level
TEST TONE
you want to adjust.
• The channel switches as
shown below each time the
button is pressed.
Remote control unit
SURROUND R
FRONT L CENTER FRONT R
SUBWOOFER SURROUND L (SURR. BACK L SURR. BACK R)
2 Adjust the volume level of the selected speaker
while the channel level is displayed.
Remote control unit
According to SURROUND mode and SPEAKER
CONFIGRATION, test tones should not be out
from some speakers.
When you select STEREO about the surround
mode and SW NO about SPEAKER
CONFIGRATION, test tones are out from Front
L and R speakers.