Use Top Cabinet Template For Preparation Of Top Cabinet; Check For Proper Damper Operation - Hisense HMO173SR Guía De Uso Y Cuidado

A2.

USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for
through, and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet bottom.
• Drill the holes, following the instructions on the TOP CABINET TEMPLATE.
CAUTION :Wear safety goggles when drilling holes in the cabinet bottom.
A3.

CHECK FOR PROPER DAMPER OPERATION

Exhaust Adaptor(absent on models shipped for recirculation exhaust)
Blower Plate
• Place the microwave in its upright position, with the top of the unit facing up.
• The exhaust adaptor only used for top exhaust and outside back exhaust. It is absent
on models shipped for recirculation exhaust.
• Make sure tape securing damper is removed and damper pivots easily before mounting
microwave.
• Attach the exhaust adaptor to the blower plate by sliding it into the guides.Secure the
adaptor with one Sheet Metal Screw provided.
• You will need to make adjustment to assure proper alignment with your house
exhaust duct after the microwave is installed.
Step-by-step installation guide
the top support screws
Damper
Back of microwave
Screw
Guide
, a hole large enough for the power cord to fit
Blower Plate
Guide
15