RIDGID AC11303 Manual Del Operador

To register your RIDGID product,
please visit: http://register.RIDGID.com
WARNING:
To reduce the risk of injury, do not attempt to use
this product until you have read thoroughly and
understand completely this Operator's Manual
and the Operator's Manual for the R4020 Tile Saw.
UNPACKING
This product requires assembly.
n Carefully remove the product from the box. Make sure
that all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
n Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
n Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
n If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
LOOSE PARTS LIST
See Figure 1.
TOOLS NEEDED
See Figure 2.
Adjustable Wrench or 13 mm Wrench
988000-684
10-14-11 (REV:02)
OPERATOR'S MANUAL
TILE SAW STAND
AC11303
FOR USE ONLY WITH THE RIDGID R4020 TILE SAW
SAVE THESE INSTRUCTIONS
ASSEMBLING THE STAND
See Figures 3 - 7.
n Assemble upper and lower legs by inserting lower legs
into the end tubes of the upper legs.
n Position the leg assemblies labeled "L" and "R" so that
they resemble an "X". Align holes for hardware.
NOTE: The angled ends of the leg assemblies should
form the base of the "X" and the threaded holes in the
assemblies should face outward.
n Insert bolt (M8 x 85 mm) through leg assembly labeled
"L", the spacer, and then the leg assembly labeled "R".
Install nut (M8). Do not tighten. Repeat the process with
the remaining leg assemblies.
n Using screws (M6 x 18 mm), secure support brace to the
leg assemblies labeled (L). Do not tighten. Repeat the
process with second support brace and leg assemblies
labeled "R".
n Position table (left) between leg assemblies labeled "L"
as shown. Secure in place using bolts (M8 x 40 mm) and
nuts (M8). Do not tighten. Repeat the process with table
(right) and leg assemblies labeled "R".
n Place stand on level ground. Line up holes in tile saw
feet with the posts on the stand. Position tile saw onto
the stand, so that the posts on the stand come through
the holes in the saw feet. Make sure that the tile saw feet
are flush against the stand and that all the stand legs are
touching the ground.
NOTE: The saw is not properly installed, if the posts on
the saw stand do not visibly extend through and beyond
the holes in the saw feet.
n Tighten the screws securing the support braces. Make
any necessary adjustments, then tighten remaining
hardware until the stand can fold without binding.
n Make sure the stand is sturdy and on level ground before
using the tile saw.
CALIFORNIA PROPOSITION 65
WARNING:
This product may contain chemicals, including
lead, known to the State of California to cause
cancer, birth defects or other reproductive harm.
Wash hands after handling.
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 35, Hwy. 8, Pickens, SC 29671
1-866-539-1710 / www.ridgid.com
English