Steren COM-840 Manual De Instrucciones página 104

Click on 'Wireless Management'- 'AP Setup' - 'Basic' and select and save
radio mode as WDS or AP + WDS.
Click on 'Wireless Management'- 'AP Setup' - 'Security' and select and the
same WDS security settings as for R1 .
Click on 'Wireless Management'- 'AP Setup' - 'WDS.' You may choose to
click on AP Scan to scan for R1, select R1 in the window that appears and
click on the connect button at the bottom of the list in this window. The SSID/
name and MAC address of R1 will automatically be entered, and you can
click on the Add button to finalize. Alternatively, you may manually enter the
name and MAC address of R1 then click add.
Note:
- Please make sure the channel matches in both routers. Click on 'Wireless
management'- 'AP Setup' - 'Basic', check that channels are the same, and
change and save if necessary.
- As there are sometimes compatibility issues between brands, you may
need to use Wireless-G and not Wireless-N. Change settings in both rou-
ters. In the Netis router click on 'Wireless management'- 'AP Setup' - 'Basic'
and select and save a setting that does not include Wireless-N.
- Please make sure that R1 and R2 are in the same IP range, that is if the IP
of R1 is 192.168.1.1, then the IP address of R2 should be 192.168.1.x (the
range of x runs from 1 through 255 but 1 should not be used as it is already
taken by R1, and other equipment in the network having static/permanent
IPs should also be avoided.
38