Steren COM-840 Manual De Instrucciones página 126

• Check if the WAN LED is ON. If not, verify that the
physical connection between the router and the DSL/
Cable modem is firmly connected.
• Ensure the DSL/Cable modem is working properly.
• For many service providers it is required that a
registered Ethernet card MAC address isa sent
through to make a connection. Try cloning the
network adapter' s MAC address to the WAN port of
the router. Utilize the clone MAC address button and
save in the Internet setup area of the interface. See
I can browse
4.4 if further information is needed.
the router's
• Try resetting the connection and acquiring a new IP
Web-based
in your computer's operating system.
interface but
cannot access
• Your modem may have the same IP as the router
(192.168.1.1). You will need to change the router's IP.
the Internet,
Click on 'LAN Setup'- 'LAN IP Address' in the router's
or experience
interface and you will see this IP in the main interface.
erratic Internet You may edit it to something different (192.168.2.1 for
example). After entering the new IP, click on 'Save'
connectivity.
below, the router will reboot, and you will need to
enter the user name and password again. Check
your system status for IP again, and test connection.
Remember this new LAN IP for your router as you will
need it to access your router's interface in the future.
Make sure you have selected the correct
•
connection type in (Dynamic IP Address, PPPoE, or
Static IP) as required by the ISP in the Internet setup
area of the router's interface. Also ensure you have
entered the correct settings provided by the ISP if
required.
60