Country Switching For Cb Radio; Codes And Its Corresponding Mode Channel; Channel Conversion Option Of Code: D, Eu, E, Pl, U And Us Only; Other Functions - Albrecht AE2990 AFS Manual De Instrucciones

Position 7 : Speaker
High quality, impact resistant output speaker for clear output reception.
Position 8 : Electret Microphone
Front mounted, electrostatic condenser microphone for clear high quality transmission
power. You should hold the radio 2-4 inches from your mouth and speak in a normal voice.
Position 9 : Battery Case
Slide on battery case, which contain 9 "AA" batteries. (See "batteries" for installation
instructions). We recommend only using AA Ni-MH rechargeable batteries only in this radio.
Multi mode Channel: this feature allows the user to convert the radio to multi channels.
Please observe the regulations in the different countries. You are only allowed to work on the
channels and with the operating modes which are allowed in the Country's regulations.
Only radio amateurs with a valid amateur radio license are allowed to use all the available
possible settings of this radio. Radio amateurs find the installation procedure hints on our
download server under "Amateur Radio"
In the factory default settings only selection between the possible CB radio modes is
possible.
Code d: Germany (80 FM4W; 40 AM 4W and SSB 4W), Czech and Slovak Republics.
Code EU: Present Europe Standard (= E) (most countries) 40AM, 40 FM/SSB 4W
Code E: Spain, Italy and new European Standard 40CH. AM/FM/SSB 4W
Code PL: Poland 40 CH, AM/FM/SSB 4W "0" Raster Poland (Frequencies with – 5 kHz
offset)
Code U: * UK; U1 international channels CH 1 to 40; U2 UK CH 1to 40, both in FM
Code US: 40 ch. (AM/SSB 4W), restricted mode for USA without FM
*Frequency display is not necessary for UK mode
In Austria it is (still) forbidden to use this radio at all, because Austria does not (yet) accept
any CB radio which can be switched to any other country setting.
In DK, H, IS, and M it is only allowed to use FM modulation (in code position d, EU or E)
Before national implementation of the new common European CEPT Standard ECC
DEC(11)03 in relevant countries please use AM only with LOW power manual setting, if necessary.

Channel Conversion option of Code: d, EU, E, PL, U and US only

1. Turn Off the unit (Volume switch off)
2. Press ML/MS button & hold
3. Turn ON the unit
4. Release ML/MS button
5. The display will show the current setting of code: d, EU, E, PL, U or US.
And then press the "UP/DOWN" buttons to select the desired code.
6. Turn OFF the unit to set the selected code
7. Turn ON the unit to operate on the selected code
BEEP Tone and Roger Beep: To enable the beep tone and roger beep, press and hold the
"SCN/ M/SCN" button for 3 sec. The display show up the

Country Switching for CB Radio

Codes and its Corresponding Mode Channel

OTHER FUNCTIONS

24
icon, press SCN/ M/SCN