Testing Saw Chain Lubrication; After Finishing Work; Preparing For Transportation Or Storage - Stihl MSE 141 C Manual De Instrucciones

English
To test the controls:
► Disconnect the chain saw from the power supply.
► Attempt to depress the trigger switch.
If the trigger can be depressed without first depressing the
trigger switch lockout, take the chain saw to an authorized
STIHL servicing dealer to be repaired before use.
► Connect the chain saw to the power supply and hold it
firmly with both hands – your left hand on the front handle
and your right hand on the rear handle. Release the chain
brake and switch on the chain saw by depressing the
trigger switch and trigger switch lockout.
If the chain does not start rotating, engage the chain brake
and disconnect the chain saw from the power supply.
Take the chain saw to an authorized STIHL servicing
dealer to be repaired before use.
► Connect the chain saw to the power supply and hold the
chain saw firmly with both hands – your left hand on the
front handle and your right hand on the rear handle.
Release the chain brake and switch on the chain saw by
depressing the trigger switch and trigger switch lockout.
Then release the trigger switch.
If the saw chain does not stop rotating after you release
the trigger switch, engage the chain brake and disconnect
the chain saw from the power supply. Take the chain saw
to an authorized STIHL servicing dealer to be repaired
before use.

15.3 Testing Saw Chain Lubrication

WARNING
Never operate your saw without bar and chain lubrication. If
the chain runs dry, the cutting attachment will be damaged
beyond repair within a very short time. A damaged chain
may break, resulting in severe or fatal personal injury.
Always check chain lubrication and the oil level in the tank
before starting work and periodically during work.
38
To confirm that the chain lubrication oil is flowing properly:
1
► Check the oil sight glass.
► If the oil level reads below the marking "OIL min" (1), refill
the oil tank with chain oil.
► Connect the chain saw to the power supply.
► Disengage the chain brake, @ 12.2.
► Point the guide bar toward a bright surface.
► Switch on the chain saw, @ 14.1.
The saw chain should throw off a small amount of oil.
If the chain lubrication oil cannot be seen, check the oil
tank for chain lubrication oil.
Refill the tank as necessary.
► Test the saw chain lubrication again.
► If saw chain lubrication oil is still not visible, the chain
lubrication mechanism is not functioning. Take the saw to
an authorized STIHL servicing dealer to be repaired
before use.

16 After Finishing Work

16.1 Preparing for Transportation or Storage

WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, switch off the chain saw,
engage the chain brake and remove it from the power supply
16 After Finishing Work
0458-729-8621-A