Troubleshooting Table - Kohler K-527 Guia De Instalacion

Installation Checkout (cont.)
Verify that the water flow is sufficient for your showering needs.
Troubleshooting
CAUTION: Risk of personal injury. The valve may contain
hot water; be careful when draining any residual water.
IMPORTANT! Turn off the power and water supply to the valve
before performing any maintenance.
NOTICE: Valve maintenance should be performed by a KOHLER
Authorized Service Representative.
This troubleshooting guide is for general aid only. For service and
installation issues or concerns, call 1-800-4KOHLER.

Troubleshooting Table

Symptoms Probable Cause
Control panel A. Valve is not
1.
is not lit.
B. Interface cable
C. Circuit breaker has
D. The valve memory
E. A "straight-
F.
Kohler Co.
Recommended Action
A. Plug the valve into
plugged into the an outlet.
outlet.
B. Check all interface
connections may cable connections,
be loose or connect if needed.
disconnected.
C. Reset the circuit
been tripped. breaker.
D. Disconnect and
may require reconnect the valve
resetting. power cord from the
electrical outlet.
E. Connect the interface
through" cable or to the valve using a
"cross-over" cable or
coupler was used
to connect the coupler.
interface to the
valve.
If none of the F. Contact your Kohler
recommended Co. Authorized
actions for the Service
above issues Representative.
correct the
symptom, the
valve or interface
requires servicing.
9 1143086-2-E