Installation; Making The Electrical Connections - HAMPTON BAY 19854-000 Guía De Uso Y Cuidado

Installation

1
Preparing the unit for installation
WARNING: Before starting the installation of this fixture
or removal of a previous fixture, disconnect the power by
turning off the circuit breaker or by removing the fuse at
the fuse box.
Carefully unpack and lay all parts on a clean, level surface.
Install the mounting bracket (CC) to the junction box with two junction
box screws (AA).
NOTE: The pre-assembled
bracket (CC) should protrude out from the junction box.
2

Making the electrical connections

NOTE:
Make the connections to a 120V AC 60Hz circuit.
Connect the white, black and ground wire from the xture
to the white, black and ground wire of the supply circuit using
the wire connectors (BB) provided.
If the supply circuit does not have a bare ground wire then the
ground wire from the xture pre-assembly must be connected
to the green hex screw located on the mounting braket (CC).
CC
BB
mounting screws on mounting
3
Installing the fixture
Allow the mounting screws on the mounting bracket (CC) to
extend through two canopy holes on the xture assembly (A).
Secure the xture assembly (A) to the mounting bracket (CC)
by threading the two canopy nuts (DD) to the ends of the two
mounting screws.
5
Please contact 1-855-HD-HAMPTON for further assistance.
CC AA
CC
DD A
HAMPTONBAY.COM