Publicidad
LED light type 300 Marine
Type 300CA - for pool with liner
Mounting instructions:
1. Cut out a hole in the pool frame, see measurement for hole type 300CA.
2. Apply some water-resistant grease in the threads of the niche.
3. Fixate the niche in the pool frame with enclosed screws and washers. N.B! Cable gland upwards.
4. Thread the cable conduit in the niche and in the junction box. The thread shall be sealed with e.g. thread tape.
The cable conduit shall be placed so that the bend radius is not below 100 mm.
5. Fixate the self-adhesive packing on the brim of the niche.
6. Insert the liner.
7. Fill the pool with water up to about 10 cm below the niche, make a small cut in the liner in the center of the niche (not to
close to the edge).
8. Mount the sealing ring with the packing under.
9. Cut the liner clean around the inside of the sealing ring.
10. Place the supplied spacer on the cable of the lamp where it runs through the cable gland of the niche.
Tighten the cable gland in the niche to seal the cable. Insert the cable in the conduit and connect to the junction box.
Wrap excess cable behind the lamp and assemble the lighting unit in the niche.
11. Mount the front ring.
- for pool walls of wood,
sheet or plastic
Conduit
Washer (3x)
Nut M6 (3x)
Pool frame work
plywood/sheet
Item no 124291: LED red/green/blue
Item no 124391: LED white
Foam
Niche
Gasket 1.5mm self-adhesive
Gasket 3mm
Liner
E
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
Countersunk
screw M6x20
(8x)
Sealing ring
11
Surface treatment
E
The tolerance class in accordance with this
part of ISO 2768-1
ENGLISH
Plywood
Spacer
Countersunk screw M5x10 (6x)
Front Marine
Surface treatment
Designed by:
Washer (6x)
The tolerance class in accordance with this
Assembly drawing no.
part of ISO 2768-1
Installationsbild
belysning typ 300CA LED
för pool med duk
Screw (2x)
M5x20
Lamp unit
Designed by:
Drawn by: Date
TS
2011-11-30
Assembly drawing no.
Art.no.
Scale
Foam
Liner
Drawn by: Date
Approved by:
TS
2011-11-30
Art.no.
Scale
Revised by: Date
Drawing number
Rev.no.
M11604 0
Sid 1(2)
Approved by:
Revised by: Date
Publicidad
