Electric Installation; Hydraulic Installation - Skymsen DAL-06 Manual De Instrucciones

Ocultar thumbs Ver también para DAL-06:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.1.2 Electric Installation

This equipment has been designed for 110/220 V (50 or 60Hz) or 220 V (50Hz). When you
receive the equipment check tension printed in the tag on the electric cable.
If necessary, adjust the equipment to the desired voltage. To do so, remove the Rubber Lid
located at the bottom of the Equipment Base No. 08 (Pic.01) and adjust the Selector Switch
to the desired tension.
The cord has a plug with 3 pins, and the central pin is intended to the grounding. It´s
mandatory that the three points are connected before starting the appliance.
Make sure the power grid where the appliance is installed is compatible to the
tension is compatible with the tension indicated in tag in the feeding cable.

2.1.3 Hydraulic Installation

It is recommended to install the machine near a drain or channel the water outlet. It is
also necessary to install a faucet (diameter ¾) with tap water directly on the product to
be stripped. Alternatively, it is possible to pick up water from another faucet through the
water inlet pipe.
NIPPLE
Water entrance to be
connected to the Nipple.
WATER EXIT PIPE
For water and residues.
Install the machine near
a water sink.
The water outflow jet shall not drop beyond the disc centre as shown on Picture 05.
The water outflow shall not exceed 2.5 litres per minute.
IMPORTANT
PICTURE 04
PRODUCT ENTRANCE
It is mandatory to let
water flow directly on
the product.
7

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Dal-06s

Tabla de contenido