Pre Operation; Importante; Operation; Starting - Skymsen DAL-06 Manual De Instrucciones

PICTURE 05
WATER ENTRANCE
WATER OUTFLOW JET
DISC

2.2 Pre Operation

Before to use the equipment all parts to be in contact with the product shall be washed
with water and neutral soap (see item 3.3 Cleaning).
Make sure the equipment is firm on its working place.

IMPORTANTE

Before starting processing, the products must be clean, without soil and without
sand.

3. Operation

3.1 Starting

To turn on your appliance you should follow the directions below:
- Plug the equipment to the electric network.
1 - Verify if the Lid No. 06 (Pic.01) is properly positioned.
2 - Press the ON/OFF Switch No. 04 (Pic.01) to position "I".

3.2 Operating Procedures

IMPORTANT
Never place the hand on the Disc while it is on movement.
- Place the product inside the equipment.
- Close the Lid.
- Open the water flow.
8