HP Color Laser 150 Serie Guía De Referencia página 2

Problem Cause/Solution
The Wireless Wireless connection mode is on but the wireless network connection is not set up yet. Try
light is the following solutions in order until the problem is resolved:
blinking blue.
1. Verify that the printer is within range (30 m or 100 ft) of the wireless network.
2. If you are using a USB cable to temporarily connect the printer and computer during
3. Restore the wireless network settings:
4. Restart the printer and the router.
5. Manually connect the printer to your wireless network. Use Wi-Fi Protected Setup (WPS)
6. Uninstall and reinstall the HP printer software.
The Wireless The printer driver might not be installed. Try installing or reinstalling the printer driver, and
light is then try printing again.
on, but you
If you still cannot print wirelessly, the printer and your computer or device might be
cannot print
connected to different networks. Try the following:
wirelessly.
1. Check the network that the computer is connected to.
2. Check the printer's network name (SSID) info on the Configuration Report/Network
3. Resolve any connection issues, and then continue to install the software.
Set up a wireless connection using Wi-Fi Protected Setup (WPS)
1. Press the WPS button
2. Within two minutes, press and hold the Wireless button
and then release the button.
3. Wait while the printer automatically establishes the network connection. It takes up to two minutes. When the
network connection is established, the Wireless light
4. Continue to install the software.
Set up a Wi-Fi Direct connection
Use Wi-Fi Direct to connect to a printer wirelessly—without connecting to an existing wireless network. To use
Wi-Fi Direct:
• Make sure Wi-Fi Direct is enabled on the printer.
• To check the Wi-Fi Direct name and password (Network Key), press and hold the Resume button
printer control panel for 10 seconds. A report prints with information on your machine's network connection and
configuration.
To learn more, visit www.hp.com/go/wifidirectprinting.
2
set up, do not connect the USB cable until the software prompts you to do so. If you
connected the cable before being prompted, unplug the cable and then restore the
wireless network settings as directed in the next step.
a. Remove the USB cable from the printer.
b. Press and hold the Wireless button
c. When the Attention light and the Power light
Wireless button .
d. After the Wireless light
if your router supports it. See the WPS instructions in the next section.
Summary. To print the report, press and hold the Resume button
control panel for 10 seconds.
on your router.
on the printer control panel for 20 seconds.
start blinking together, release the
starts blinking blue, continue to install the software.
on the printer control panel for at least 3 seconds,
stops blinking and glows steady blue.
on the printer
on the