Troubleshooting - Worx WX543L Manual Del Usuario

WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
Always use a blade suited to the material and material
thickness to be cut. For tight curves it is best to use
a narrow saw blade. When sawing metal or similar
materials, apply coolant/lubricant alongside the cutting
line.
Always ensure the workpiece is firmly held or clamped
to prevent movement. Any movement of the material
may affect the quality of the cut. The blade cuts on the
upward stroke and may chip the uppermost. Ensure
your uppermost surface is a non-visible surface when
your work is finished.
For easier control, use low speed to start cutting and
then increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for
wear and lubricated with a drop of oil. If it is worn, it
must be replaced.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
Only genuine WORX batteries, accessories and parts
should be used with this product. Failure to do so, will
void all warranty claims.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.
Cordless Jigsaw

TROUBLESHOOTING

Symptom Possible Causes
Overload
Battery
The tool
temperature too
suddenly
high
stops during
operation.
Low battery
capacity
Possible Solution
Relieve the load
on the machine
immediately and
allow cooling for
approx. 30 sec-
onds by running
the machine on
no-load.
Charge the bat-
tery pack.
11
EN