Wiring Schematic - COZY W255GPPR Instrucciones De Instalación Y Funcionamiento

Ocultar thumbs Ver también para W255GPPR:

Tabla de contenido

Idiomas disponibles

NOTE: This fan kit is to be installed after installation

of the wall furnace and with the wall furnace front

panel in place.

STEP 1.

This appliance, when installed, must be electrically

grounded in accordance with local codes, or in the

absence of local codes, with the latest edition of

the National Electric Code, ANSI/NFPA No. 70.

In Canada, see the current Canadian Electrical

Code CSA C22.1.

STEP 2.

Set fan kit on top of the wall furnace front panel.

Using the back top edge of the fan kit cabinet as

a guide, mark a horizontal line across the wall.

Mark a small vertical line which aligns with the slot

located toward the rear of the fan kit casing.

STEP 3.

Using the four one inch screws provided, secure

the wall mounting bracket to wall 1/8" below the

horizontal line. Fan attachment bracket must be

up and threaded nut sert aligned with the small

vertical line.

Note: Anchors (not provided) may be required.

STEP 4.

Remove junction box and connect 115v power

supply in accordance with the wiring diagram.

Replace junction box.

STEP 5.

Set fan kit on top of wall furnace front panel. Slot

should align with the nut sert. Secure fan kit to

wall mounting bracket with thumb screw provided.

FIG. 14

WHITE

115 VAC 60 HZ - LESS THAN 12 AMPS. IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THIS APPLIANCE MUST BE

REPLACED, IT MUST BE REPLACED WITH TYPE THERMOPLASTIC 105 DEGREE C WIRE OR ITS EQUIVALENT.

MODEL WFF81-C OPTIONAL FAN KIT - (Optional)

Installation Instructions

WFF81 - C

BLACK

MOTOR

FIG. 13

JUNCTION

BOX

THREADED

NUT SERT

FAN

ATTACHMENT

BRACKET

WALL

MOUNTING

BRACKET

ONE INCH

SCREW (x4)

FAN KIT

WALL FURNACE

FRONT PANEL