Leggett & Platt Symmetry SM Guía De Preparación página 5

STEP 6
Reinstall (2) hinge bolts through holes. Reinsert (2)
captive pins into hinge bolts (FIGURE 5). Do for both
sides of base.
NOTE: ROUTE CAPTIVE PIN PLASTIC STRAPS
BETWEEN BASE FRAME AND DECKBOARD OF
BASE. PLASTIC STRAPS MUST NOT INTERFERE
WITH ANY BASE MECHANISMS.
STEP 7 (if applicable)
Plug electrical power cord into power brick. Plug
brick power cord into control box. Secure connection
using cable latch (FIGURE 6).
Note: Align pins before inserting plugs.
STEP 8
Plug electrical power cord into power outlet.
Note: An electrical surge protection device is
recommended (not included).
SETUP
FIGURE 5
FIGURE 6
PLASTIC
STRAPS
BASE FRAME
WARNING
!
POWER CORDS MUST NOT INTERFERE WITH ANY
ADJUSTABLE BASE MECHANISMS.
DO NOT WEAVE CORDS THROUGH BASE
STRUCTURE.
DECK
BOARD
5