Publicidad
WARNING:
If you do not
follow these
instructions
exactly, a fire
or explosion
may result
causing
property
damage,
personal
injury or loss
of life.
1.
STOP! Read the information on the safety label.
2.
Set temperature control knob located on top of cabinet
to lowest setting.
3.
Remove temperature control knob by pulling straight up.
4.
Remove cabinet.
5.
Push in gas control knob slightly & turn clockwise
to "OFF".
Gas Control Knob
PILOT
ADJ
6.
Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information on
the safety label. If you don't smell gas, go to the
next step.
7.
Open sight glass cover.
8.
Locate red piezo ignitor button inside gas control
compartment. Locate pilot behind sight glass. (Follow
metal pilot tube from gas control).
9.
Turn gas control knob counterclockwise
"PILOT".
1.
Set the temperature control knob to it's lowest setting.
2.
Remove temperature control knob.
3.
Remove cabinet.
English Manual
BBSK-CDV LIGHTING INSTRUCTIONS - ( OPTIONAL )
FOR YOUR SAFETY READ BEFORE LIGHTING
A.
This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B.
BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT try to light any appliance.
• DO NOT touch any electric switch.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
LIGHTING INSTRUCTIONS
NOTE:
Knob can not
be turned from
"PILOT" to
"OFF" unless
knob is pushed
in slightly.
Do not force.
TURNING OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call
the fire department.
C.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob
will not push in or turn by hand, don't try to
repair it, call a qualified service technician.
Force or attempted repair may result in a
fire or explosion.
D.
Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
Sight Glass
10. Push in gas control knob and hold in. Immediately
begin a series of pushing and releasing the red piezo
ignitor button, while observing the pilot through the
sight glass. Continue to spark until pilot is lit. Continue
to hold the gas control knob in for about one (1) minute
after the pilot is lit. Release the gas control knob and
it will pop back up. Pilot should remain lit. If pilot goes
out, repeat steps 4 thru 9.
• If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician
or gas supplier.
11. Close sight glass cover.
12. Turn gas control knob counterclockwise
13. Replace cabinet.
14. Replace temperature control knob.
to
15. Set temperature control knob to desired setting.
4.
Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5.
Replace cabinet.
6.
Replace temperature control knob.
Page 11
Sight Glass Cover
Pilot
to "ON"
84517-C
Publicidad
