Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
12. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch
on wall control, then set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by pressing the L1 button;
test the dimmer function by pressing the L1 button and holding it
down for 1 second. Test fan speeds with the different fan speed
buttons. If the wall and/or handheld remote control operates all of
the functions of the fan, battery has been installed correctly. If the
wall and/or handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch (located on
top of the motor housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without feeling
a difference in your comfort.
Important: Reverse switch must be set either completely to the LEFT
or completely to the RIGHT for fan to function. If the reverse switch is
set in the middle position (diagram 3), fan will not operate.
NOTE: If the wall control/handheld remote control interferes with
other appliances, follow instructions in Section 13.
13. Re-syncing Fan and Remote.
If it becomes necessary to re-sync your fan and wall control/handheld remote control, turn power off and then
on. If using the wall control, set slider switch on wall control to the ON position. Within 60 seconds of turning on
the wall control, press and hold the fan OFF button on the wall control for 5 seconds or until light blinks twice or
blades begin to turn.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring the
power, press and hold the OFF button on the front of the handheld remote control for 5 seconds or until light
blinks twice or blades begin to turn.
Test the light and fan functions to confirm the fan and wall control/handheld remote control are synced. See
Section 11 for "Remote Control Operation." .
(switch not functional on handheld remote)
page 9
-
1 1
wall control
handheld
remote control
motor
housing
(topside)
reverse switch
diagram 2
diagram 1
diagram 3
Publicidad
Capítulos
Tabla de contenido
