5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin and
clip. Lower hanging ball and remove stop pin. Then
slide hanging ball off downrod. [Refer to diagram 1.]
Remove vice from safety cable by loosening the screw
and nut on the vice. Loosen yoke set screws and nuts
at top of motor housing.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires -- this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to
use.Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [Refer to
diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip previously removed. Tighten yoke set screws
and nuts securely. [Refer to diagram 2.]
Slide yoke cover and canopy over downrod. [Refer to
diagram 3.]
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod -- the top
of the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [Refer to
diagram 4.]
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
[Refer to diagram 2.]
set screw
diagram 1
electrical wiring
diagram 2
electrical wiring
diagram 3
diagram 4
page 4
hanging ball
clip
safety
cable
vice
downrod
clip
downrod
yoke cover
set screw hole
hanging ball
stop pin
stop pin
pin
nut
screw
yoke set
screw
and nut
pin
safety cable
canopy
motor
housing