Assembling Instructions; Install Lower Bar; Install Curved Handle; Installing The Grass Box - Grizzly ARM 4034 Lion Set Traducción Del Manual De Instrucciones Original

field which, under certain
circumstances, may impair
the functionality of active or
passive medical implants.
To reduce the risk of serious
or lethal injuries, we rec-
ommend that persons with
medical implants consult
their doctor and the manu-
facturer of their medical
implant before operating the
machine.

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a spe-
cialist or contact our service directly

Install lower bar

1. Open the lower bar (4) and move it to
the desired inclination.
2. Fix the lower bar by means of the pre-
mounted quick-release levers (5).

Install curved handle

1. Fasten the curved handle (1) with the
nuts, the washers and the upper tight-
ening levers (2) to the right and left of
the lower bar (4).
2. Clipping in the cable holders: Clip the
cable holders (
bar to fixate the machine cable
( 16).
If you loosen the quick release le-
vers, you can fold down the curved
handle and the lower part of the
handle for storage of the device.
15) onto the lower

Installing the grass box

The collection box is already completely
preassembled.
1. Loosen the Phillips screw (20a) on the
carrying handle (20).
2. Place the carrying handle (20) on the
upper side of the grass collection box
(13) and screw it tight with a Phillips
screw (20a) from below.
3. Place the plastic tabs (13a) over the
grass collection box rods (13b).
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!

Initial Operation

Before operating the machine,you must
- install the upper and lower upper han-
dles:
- install the collection bag
Caution! Risk of injury! During
the assembly or disassembly of
the collection bag, the engine
must be turned off and all mov-
ing parts must have come to a
standstill. Remove the battery
from the device before carrying
out any work.

Insert/remove battery

Switch off the device, pull the con-
tact chip (
blades to come to a stop. There is
a risk of personal injury.
1. To insert the battery (7) into the de-
vice, push the battery along the guide
GB
17) and wait for the
27