Messages Of Information Or Warning; Alarms; Power Supply Failure (Black Out); Smoke Temperature Probe Alarm - BOREAL RADIOFRECUENCIA Serie Instrucciones De Instalación, Uso Y Mantenimiento

10. MESSAGES OF INFORMATION OR WARNING

Before your stove or insert enters into an alarm state, a series of messages will appear on the screen of the display, which do
not block the operation of the stove, simply these messages are activated as information or self-protection on the stove:
End hours service: Indicates that maintenance is required on your stove. See section "7.10 Maintenance Review"
•
in this manual.
•
HOT
appliance is self-protected and after cooling, it returns to the working mode. In case you observe this message often on your
EXHAUST
remote control, you must contact the Technical Assistance Service in your area or your installer, in order to check the reasons
of this smoke overtemperature.
MENU
•
elevated temperature. Generally this message appears due to a lack of a correct combustion and/or proper
ventilation. In case you observe this message often on your remote control, you must contact the Technical Assistance
Service in your area or your installer, in order to check the reasons that lead to the appearance of this message.

11. ALARMS

In case of an anomaly during the operation, the electronics of the stove or insert intervenes and highlights the irregularities
that have ocurred in the different working phases, depending on the type of fault.
Every alarm situation blocks the stoves to be automatically blocked. By pressing button 3 we can unblock it. Once the stove has reached the
appropriate cooling temperature, the user can restart it up.
11.1

POWER SUPPLY FAILURE (BLACK OUT)

In the event that power supply is cut for less than 30 seconds, the stove will restart and continue with its normal working state.
In the event that power supply is cut for greater than 30 seconds, when power is restored, the stove, as a safety measure,
goes straight to the Final Cleaning stage until the stove temperature reaches the appropriate cooling temperature.
ALARM 2
SMOKE
PROBE
11.2
This alarm goes off when the probe in charge of detecting the exhaust stack temperature is disconnected or is broken. During
the alarm status, the stove will be in the turn-off stage.
MENU
11.3

SMOKE TEMPERATURE EXCESS ALARM

It goes off when the probe detects a smoke temperature higher than 270°C. Therefore the control shows the following
message:
During the alarm state, the stove will be in the turn-off stage.
ALARM 4
FAILURE
11.4
ASPIRATION
It goes off when the smoke extraction fan breaks down. If this happens, the stove stops and the control will show up the
following alarm. Right after, the turn-off stage will be immediately activated.
To deactivate the alarm press button 3 and the stove will come to the normal state after doing the final cleaning.
MENU
Hot exhaust: This message means that the stove has reached a very high smoke temperature. The
Hot temp card: This message informs that the electronic board has an

SMOKE TEMPERATURE PROBE ALARM

DAMAGED SMOKE EXTRACTION FAN ALARM

EN
END
SERVICE
HOURS
MENU
HOT TEMP
CARD
MENU
14:42
22º C P-3
FINAL
CLEANING
MENU
ALARM 3
TEMP.
SMOKE
MENU
45