Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
15. Reinstall the Cover Assembly and use a hex wrench
to push it below the threads at the rear of the Hous-
ing. (Refer to Dwg. TPD1290)
16. Install the Housing Cap (42) and using the spanner
plug furnished in the Tool Kit, tighten the Cap be-
tween 5 and 6 ft–lb (8 and 9 Nm) torque. (Refer to
Dwg. TPD1291)
MAINTENANCE SECTION
(Dwg. TPD1290)
17. Make certain the Drive Shaft rotates freely and then
fill the mechanism with fluid and reassemble the tool
as instructed in the section, CHANGING THE
MECHANISM FLUID.
(Dwg. TPD1291)
Publicidad
Tabla de contenido
