Beninca IRI.KPAD Guía Rápida página 25

- Type 3 >(2 beeps) if a Fixed Code is desired.
Note: If you are using only one receiver, the type of encoding must match that of
the Administrator PIN entered.
MENU 8 (TO CHECK THE CODING TYPE)
If allows to check the type of radio coding related to a determined code stored in
memory. After typing key 8, two beeps followed by an interval are heard.
The system is waiting for the code.
- Type the code to be checked followed by #.
If the code is memorised, IRI.KPAD replies with 1, 2 or 3 beeps:
- 1 beep: Rolling-code
- 2 beeps: Advanced rolling code (ARC)
- 3 beeps: Fixed Code
MENU 9 (CODE REPETITION ACTIVATION WITH #)
Through this function it is possible to enable the button, # as code "repeater", during
the 20 seconds following the code introduction.
This function might be useful to check the automatic systems preset with
Step-by-Step cycle operation (e.g.OPEN>STOP>CLOSE>STOP>OPEN>).
After 20 seconds, the system exits the repetition mode and a new valid code shall
be typed in again.
In the factory configuration this function is disabled.
After typing key 9, two beeps followed by an interval are heard.
The system enters a wait state.
- Type in 1 if the function is to be activated.
- Type in 0 if the function is to be deactivated.
Then, three beeps are heard followed by an interval.
The device activates or deactivates the function and exits the programming mode.
COMPLETE MEMORY RESET
1. Remove the battery (if inserted), and wait 10s
2. Replace the battery and wait for device initialization (2 beep)
3. Now type in the memory reset password "1234567890", followed by #.
4. An intermittent buzz can be heard to indicate that the memory has been erased.
The reset restored the factory presetting. All customized codes and settings are removed.
RAPIDLY MEMORIZING ADMINISTRATOR PINS.
1. Remove the battery (if inserted), and wait for 10s.
2. Press and hold key 1 if the receiver is Rolling Code HCS, 2 if it is Rolling Code
ARC, and 3 if it is in Fixed Code.
3. Reinsert the battery while holding down the key. The alarm emits a signal (1 long
beep - pause - short beep).
25